|Synonyms||Trembolone Acetate, Trienbolone Acetate, Tren-A, Finaplix|
|Appearence||pale yellow or yellow powder|
|Application||Trenbolone-Acetate is the most powerfully amazing steroid of all time. Like Testosterone, by its direct mode of action Trenbolone dramatically increases IGF-1 output but to a far greater degree than testosterone.|
Trenbolone exhibits interesting stacking behavior. Combination with either Dianabol or Anadrol gives a very strong synergistic effect. Even if the same total milligram amount of steroid is used per week, results are much better with such a combination than with any of these steroids used alone.
For example, 50 mg/day of trenbolone acetate used with 50 mg/day Dianabol gives much better results in a steroid cycle than either 100 mg/day TA used alone, or that amount of Dianabol used alone. I wouldn’t recommend either of those single-drug usages for a steroid cycle, but the trenbolone/Dianabol stack has produced amazing physique changes in very many instances.
In contrast, trenbolone's stacking behavior with oxandrolone (Anavar), methenolone (Primobolan), or drostanolone (Masteron) is entirely different. If keeping the same total milligram amounts, these combinations do not outperform trenbolone used alone. So, while it's acceptable to combine these drugs, the purpose should not be to achieve increased total effect. Such combinations may be useful however to reduce side effects, or to accommodate the materials that are on hand.
If uncertain about personal response to trenbolone, the acetate ester is preferable as it clears the system quickly. It is also very desirable for short cycle use or for the ending weeks of longer cycles because the rapid clearance provides quick transition from having high levels suited for optimal results to low levels allowing recovery.
While trenbolone use is not necessary to achieve excellent results in an anabolic steroid cycle, it can be a remarkable aid towards such results.
It is important to have everything you will need at hand, the best way to cook is to do everything quickly. This prevents fluctuations in temperature and excessive oxidation of your compounds - both allow the compound to reach its strengt potential and many 'cooks' do not allow for this. Set up your water bath by boiling the kettle and adding a 2-3cm of the boiling water into the base of a pan, or similar container - work quickly from this point so the water temperature does not drop by too much. 150f is ideal for the temperature of this water but it is not greatly important.
|Notes:- The syringe is used to push the unfiltered steroid mixture through the syringe filter. Select the size of the syringe depending on how much you intend to create, the syringe can be rinsed and resed.|
Notes: The second needle is to equalize pressure as the Hormone enters the vial, it is an important step and must be done. Apply pressure to the syringe plunger to filter the mixture, you may be surprised how much force is required to filter the steroids. You must remember this is the most important part of this entire process as it is what sterilizes the Hormones. Occasionally you will find that the filter gets blocked, or that the process slows drastically, it is OK to replace a filter with a new one if this occurs. The time it takes to filter steroids depends on which steroid is being filtered.
You have now successfully completed the process of producing Hormones. It is a very straight forward process and requires no expertise. In this example 50ml of Trenbolone Acetate.