Payment & Shipping Terms:
|Product name:||Trenbolone Acetate||CAS register number:||10161-34-9|
|Molecular formula:||C20H24O3||Molecular weight:||312.4|
|Appearance::||Yellow Or Pale Yellow Crystalline Powder||Type:||Trenbolone Steroids|
Anabolic Trenbolone Steroids,
10161-34-9 Trenbolone Steroids
In contrast, trenbolone enanthate’s percentage of active steroid is nearly 20% lower. For this reason, weekly total dosing for trenbolone enanthate is a little higher than for the acetate. For the enanthate, weekly total dosing is typically 300-800 mg.
Unlike trenbolone acetate which has a half-life of only about 1 day and therefore should be injected daily, trenbolone enanthate is typically injected 2-4 times per week. The half life is probably about 5 day.
|product name:||Trenbolone Acetate|
|Alias:||Revalor-H, Tren Ace|
|Characters:||Yellow crystalloid powder.|
|Use:||Trenbolone is a steroid used by veterinarians on livestock to increase muscle growth and appetite, to increase the half-time.|
|Packing:||Zip-lock bag in silver packing.|
|1. Get a clean 1000 ml volume beaker and weigh out 100 grams of tren ace powder. Put 100 grams of tren ace raw powders into the beaker, add 20 ml of BA and 100 ml of BB;|
|2. The melting point of tren ace is 94~97 °C, we can use water bath to melt tren ace powder. Put the beaker in hot water bath which the temperature of water is about 95 to 100 °C and about 4 inches depth (Please pre-heat the water in advance.). After about 5 to 8 minutes heating in water bath, then the tren ace oil be melted. By heating in water bath, the conversion won't get dark even we heat it for a little longer time.|
|3. After the powders in the beaker are melted completely, then we add GSO into the beaker and keep brewing. Use a magnetic stirrer if you have or use a glass rod to replace the stirrer. If you are using a magnetic stirrer, please watch out the temperature. Please set up at about 95 to 100 °C. Brewing for another 10 minutes and the brewing is done and it will be ready for filtering.
Before we inject the oil, we have to make sure it is safe and sterile for use, so sterile filtration have to be done.
|Tips : You can choose to get Semi-finished liquids from us--then just need to filter,or you can also choose to get finished liquids from us-- then it is ready to inject or sell .|
Contact Person: Gavin Lee